Share

New White Paper: The Effect of Dies on Rotary Moulded Products and Productivity

New White Paper: The Effect of Dies on Rotary Moulded Products and Productivity

In a typical rotary moulder line, the die has more impact on the properties of the finished product and, arguably, on the efficiency of the line itself, than any other single piece of equipment. The direct effect that the die has on the appearance of the finished product is obvious, but there are more subtle effects too:

  • inaccurate weight control leads to waste
  • giveaway and packaging problems
  • poor release results in excessive extraction pressure causing wedging and tailing
  • incorrect choice of coating materials and finishes means rapid wear and frequent stops for cleaning because of plugging

All these problems can be avoided by good design and manufacture, but there is a lot more to achieving this than meets the eye. This paper examines the various options open to biscuit manufacturers when specifying a new die and considers the impact of each on performance and quality.

The full paper can be viewed here.

Latest News

A redesigned Tweedy Mixer 385 impact plate improves energy transfer to the dough, giving an even and consistent dou… twitter.com/i/web/status/1…

20 July 2022

Join us and @peterboroughtel in the search for the best apprentices, employers and mentors across Greater Peterboro… twitter.com/i/web/status/1…

08 July 2022

Register for our free online #Bakery #training courses in July, September and October. Our training courses are the… twitter.com/i/web/status/1…

22 June 2022

Mark Sheffield will be joining our colleagues at @Schenck_Process Thailand on stand AH21 at ProPak Asia #propakasiatwitter.com/i/web/status/1…

13 June 2022

We have published two new white papers for the #bakery industry; one analysing the results of our recent Tweedy Sup… twitter.com/i/web/status/1…

08 June 2022

Peterborough residents and businesses can get involved by offering to volunteer with the ongoing efforts, making a… twitter.com/i/web/status/1…

31 May 2022