Schenck Process Group completes acquisition of Baker Perkins
- Company News
Die-forming developed as an automated version of the time-honoured manual method of making hard candy: pouring syrup onto a cooling table until it becomes plastic, pulling it into a rope, and cutting it into pieces.
The problem, it seems clear, is that die-forming retains all the inherent disadvantages of the manual process. Air bubbles lead to a loss of clarity and sharp edges, and there is an unsightly flash line where the two halves of the die meet.
With die-forming, rapid forming of a plastic mass leads to an inconsistent product, especially when the plasticity varies. The process relies on pressure-induced flow forcing the product into the die; there is always the possibility of inconsistent die-fill as the resistance of the mass varies.
The weakness I would find most frustrating is that product innovation and appeal is strictly limited with die-forming. Fillings can be added, but have to be extremely robust to cope with the insensitive process. Stripes are possible but have to run in a straight line throughout the rope. Swirls and layering are simply not possible. Contemporary ingredients such as Xylitol cannot be used.
By contrast, and without going into detail, depositing produces a wider range of higher quality products with greater efficiency than die forming. There is consistency of quality and appearance; a more regular, consistent shape; very high levels of efficiency; and much greater flexibility.
So why do some confectioners continue to invest in die-forming lines? A perception of lower capital cost is one possible reason, particularly where volumes are low. However, once higher operating and maintenance costs are taken into account, the case for die forming is no longer clear.
I would argue that, for ambitious companies, die forming can only ever be considered a short term solution. Which begs the obvious question: why waste time and money? Move straight to depositing, and there’s no need to re-invest or change a product range - and there is protection from a competitor entering the market with a superior product.
Wishing all of our customers the very best for the holiday season and a healthy, prosperous New Year. https://t.co/5DLxOulNt123 December 2021
If you're an engineer looking for a new job, working as part of a close-knit team, check out our current vacancies:… twitter.com/i/web/status/1…08 December 2021 06 December 2021 02 December 2021 29 November 2021
A new automatic mould stacking and cooling cart system for ServoForm Mini starch-free depositors eliminates the add… twitter.com/i/web/status/1…22 November 2021
Baker Perkins Limited, Manor Drive, Paston Parkway, Peterborough, PE4 7AP UK, Registered in England: No. 5708493
© 2022 Baker Perkins. All rights Reserved.
Web Design by Studio 24